|
|
United States-English | |
|
|
 |
|
Ignite-UX Quick Start Guide: Create an Ignite-UX Server and Cold-Install Clients
Chapter 2 Cold-installing a Client Across the Network |
|
|
Table of Contents This chapter describes adding a client to an Ignite-UX server, and then installing HP-UX on that client from the Ignite-UX server over the network. You must have superuser privileges to cold-install a client. You can stop anywhere in this procedure and resume where you left off at later time. This document assumes the network boot clients are on the same subnet as the Ignite-UX server. Glossary terms are italicized when used for the first time in this manual. |
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||
 Printable version |
|
|
|
|
|
|||||||||||||||
|
|||||||||||||||
