Installing in-place on Linux Itanium

This chapter provides steps to install HP System Management Homepage (HP SMH) in-place on Linux Itanium.

“Installation for Linux Itanium”
- “Installing HP SMH on Linux Itanium systems”
- “Configuring HP SMH”

The next chapter provides steps to install HP SMH in-place on Linux systems using the Linux Deployment Utility.

“Installing HP SMH with preconfiguration”
- “Preconfiguring the HP SMH component”
- “Installing HP SMH as a single component”
“Installing HP SMH without preconfiguration”

Installation for Linux Itanium

The HP SMH installation for Linux enables you to silently install HP SMH on Itanium systems. After the installation is complete, you can configure the HP SMH settings.




	NOTE: To install HP SMH, you must be logged in as root user.

Installing HP SMH on Linux Itanium systems

To install HP SMH on Itanium systems, your system must meet the minimum requirements. For more information regarding minimum requirements, see Chapter 2 “Installation requirements”. In addition, you must have the hpsmh-2.x.x.-xx.linux.ia64.rpm.

To install HP SMH, enter the following command line:


				rpm –ivh hpsmh-2.x.x-xx-linux.ia64.rpm

A message appears indicating that HP SMH installed successfully with default configuration values.

Installing in-place on Linux Itanium

Technical documentation

» Table of Contents

» Index

Installation for Linux Itanium

Installing HP SMH on Linux Itanium systems