|
|
United States-English | |
|
|
 |
|
HP-UX Software Assistant Administration Guide: HP-UX 11i Systems > Chapter 2 Installing HP-UX Software Assistant
Installing SWA from the HP Software Depot |
|
|
For HP-UX 11i releases, you can download SWA from the HP-UX Software Assistant web page at https://www.hp.com/go/swa. This web page contains installation instructions for downloading the SWA depot and installing it on a system. If you choose to create a local or remote depot containing SWA for installation, you must have the dependent applications either on the system already or in the depot. See “Installation Requirements” for a list of dependent applications and where to find them. The installation from a local or remote depot is the same as the previous instructions on “Installing SWA from the HP Software Depot” with the exception that you should use the swcopy(1M) command with the dependent applications to include in the depot, and then use the Software Depot instructions with the swinstall(1M) command for the depot contents. To install SWA, enter the command: # swinstall -s your_depot SwAssistant The following bundles should exist on the system:
The dependencies for SWA are
To remove SWA, enter the command: # swremove SwAssistant The following objects are removed from the system:
The dependencies for SWA remain on the system. These include:
|
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||
 Printable version |
|
|
|
|
|
|||||||||||||||
|
|||||||||||||||
